www.modellmarkt24.ch; www.modellmarkt24.de
WARNING: once you have completed this procedure, it is absolutely essential to check that all
the gyros are working in the correct direction. This is accomplished by moving
the model around all three axes in turn, and checking the control surface deections - see diagrams
below. You must not y the model before doing this: crash hazard!
57
• Now move the stick for any control surface to full travel in one direction; in the following example we use the aileron
channel.
• The detected axis (aileron) is highlighted (black background). (In the receiver’s default state the value for all axes is
shown as ‘+0’; the axes can also be set manually to ‘+0’. 0 = inaktiv).
• Now turn the model through at least 45° in the direction corresponding to the stick movement. For example, if you
moved the aileron stick to the left, you must simulate a left turn with the model move the left wing down through
at least 45°.
• This process denes the one axis and direction; now you must repeat the procedure for the other two axes.
• The gyro axis 1, 2 or 3 is now displayed in the ‘Aileron / Elevator / Rudder’ display; a negative prex will appear if servo
reverse is activated.
• Once all three axes are dened, the display automatically reverts to ‘New setting: no’.
www.modellmarkt24.ch; www.modellmarkt24.de
To Next Page
Loading...
Need help?
General
