12 / 24
33506_33508_33512_33516_T1V2sh
Receiver reset
To reset the receiver, press and hold its SET button while turning on
the power to the receiver:
If the reset was triggered with the transmitter switched off or with
an unbound receiver, the LED of a receiver GR-12 HoTT lights up con-
stantly green for about 3 seconds or the red and green LEDs of a
receiver GR-16 HoTT, GR-24 HoTT or GR-32 HoTT flash 4x. Release
the button once the LEDs go dark.
If the reset is performed with a not bound receiver, you can then
start a binding process at any time.
If a reset has already been carried out on an already-connected
receiver and the associated model memory is active in the
switched-on transmitter, then the green LED of a receiver GR-12
HoTT, GR-16 HoTT, GR-24 HoTT or GR-32 HoTT should again be con-
stantly lit and thus signal a correct connection to the transmitter.
Otherwise the process has to be repeated.
Notes
• Through a RESET ALL of the settings in the receiver are brought
to the factory settings with the exception of the HoTT synchro-
nization information!
• If a reset is performed accidentally, all of these settings that
were made using the "Telemetry" menu in the receiver should
be restored.
• Resetting is particularly recommendable when you want to
switch a receiver to a different model. This makes it easy to keep
settings which do not match from being transferred.
To Next Page
Loading...
Need help?
General
