Intended use
The receiver is only suitable for use with RC multicopter mod-
els. More punctual information about receiver can be found in
the Technical data section.
The receiver is designed exclusively to be used as a bat-
tery-powered, radio controlled model, any other use is not
allowed. For any improper use no warranty or liability is ac-
cepted. Read through this entire manual before you attempt
to program or set the receiver.
Graupner/SJ constantly works on the development of all prod-
ucts; we reserve the right to change the item, its technology
and equipment.
Target group
The receiver is not a toy. It is not suitable for children under 14
years. The installation and operation of the controller must be
performed by experienced modellers. If you do not have suf-
ficient knowledge about dealing with radio-controlled models,
please contact an experienced modeller or a model club.
Features
Ð The Firmware is a specific Multicopter firmware. The
model type Surface/Heli are not available. The firmware
for Surface/Heli models can however be used. Only one
firmware can be used per time.
Ð The receiver provides copter stabilization on 3 axes
Ð Natural flight performance
Ð Very good stabilization for aerobatic figures
Ð Easy adjusting of the gyro settings
Ð Parameters setting by the HoTT Telemetry
Ð Altitude sensor for vario and altitude
Technical Data
Ð Operating temperature: - 15...+70 °C
Ð Antennas: 2 x wires 145 mm
Ð Total weight approx.: 14 g
Ð Frequency: 2400 ... 2483.5 MHz
Ð Range approx.: 4000 m
Ð Dimensions ca.: 46 x 21 x 14 mm
Ð Modulation: 2.4 GHz FHSS
Ð Current consumption: 70 mA
Ð Operating voltage: (2,5) 3,6 ... 8,4 V
To Next Page
Loading...
