Getting Started Graupner HoTT 2.4 09
ENVIRONNEMENTAL PROTECTION NOTES
When this product comes to the end of its useful life, you must not dispose of it in the ordinary
domestic waste. The correct method of disposal is to take it to your local collection point for re-
cycling electrical and electronic equipment. The symbol shown here, which may be found on the
product itself, in the operating instructions or on the packaging, indicates that this is the case.
Individual markings indicate which materials can be recycled and re-used. You can make an important
contribution to the protection of our common environment by re-using the product, recycling the basic
materials or recycling redundant equipment in other ways.
Remove batteries from your device and dispose of them at your local collection point for batteries.
In case of R/C models, you have to remove electronic parts like servos, receiver, or speed controller
from the product in question, and these parts must be disposed of with a corresponding collection point
for electrical scrap.
If you don’t know the location of your nearest disposal centre, please enquire at your local council of-
fi ce.
FCC INFORMATION
Graupner GR-16 HoTT #33508 and GR-24 #33512
FCC ID: ZKZ-33508 and ZKZ-33512
FCC Label Compliance Statement
This device complies with Part 15C of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
WARNING:
Changes or modifi cations not expressly approved by the party responsible for compliance could void
the user‘s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-
ant to Part 15C of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by tur-
ning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connec-
ted.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
This device has been evaluated to meet the FCC RF exposure requirement when used in combination
with the genuine Graupner HoTT accessoires and operated with a minimum distance of 20 cm between
the antenna and your body.
To Next Page
Loading...
Need help?
General
