57
Physical control, switch and control switch assignments
The two FX switches switch a function on "FXI" or •
off "FX
" permanently.
All other switches mentioned can have multiple •
assignments. Pay attention that you do not
UNINTENTIONALLY assign reciprocally confl icting
functions to a single switch. If necessary, note
down the given switch functions.
Typical applications:
Shut-off of an on-board glow plug heater upon •
underrun or overrun of an idle threshold point
programmed for the C1 joystick. In this case
the glow plug heater switch is controlled by a
transmitter mixer.
Automatic switch on/off of the timer to measure •
pure "fl ight time" for a helicopter by way of a
control switch on the throttle limiter.
Automatic switch off of the "AI • Rud" when
brake fl aps are extended, for example to adapt
the roll of a model to the ground when making a
landing on a slope without inducing a change of
fl ight direction due to infl uence on the rudder.
Extending landing fl aps with elevator trim adjustment •
during a landing as soon as the throttle stick is
moved beyond its switch point.
Switch on/off of the timer for measuring the •
operating time of electric motors.
To Next Page
Loading...
