Need help?Do you have a question about the GRAUPNER mc-26 and is the answer not in the manual?
General| Brand | GRAUPNER |
|---|---|
| Model | mc-26 |
| Category | Remote Control |
| Language | English |
Details receiver output assignments for helicopter models.
Guides the user through selecting or creating a new model memory.
Explains how to copy, delete, export, and import model memories and phases.
Instructions for exporting model data to an SD card.
Instructions for importing model data from an SD card.
Setting up fundamental parameters for the current model memory.
Defines how control sticks are assigned to channels for different model types.
Explains global vs. model-specific receiver binding.
Step-by-step guide for binding receivers to the transmitter.
Channel mapping for assigning transmitter channels to receiver outputs.
How to perform a range test to ensure reliable control.
Programming a switch to cut off the throttle channel for safety.
Function to save current servo positions into trim memory.
Adjusting model type settings like tail, wing, and motor presence.
Specific settings for motor control on channel 1, applicable to airplanes.
Selecting tail types (Normal, V tail, Delta, 2 ELE) for aircraft models.
Configuring aileron and flap control surfaces based on model type.
Setting servo parameters like direction, neutral point, and travel.
Detailed explanation of setting servo travel and limits.
Setting trim step values and control speed for channels 1-4.
Assigning transmitter controls to channels 5-16.
Adjusting control function travel and exponential curves.
Reducing control function travel, activated by a switch or always active.
Influencing control function travel with exponential curves.
Changing control characteristics for throttle/pitch functions.
Pairing a switch function with a proportional control's travel.
Interconnecting switches, controls, or logical switches using AND/OR logic.
Setting up to seven different phases for model memory.
Steps to create a new phase, assign name, and set timer.
Assigning switches or switch combinations to phases.
Entering phase-dependent trim settings for wing controls.
Menu for configuring wing mixers, depending on model type.
Explains aileron differentiation to compensate for winding torque.
Specific mixer settings for wing types like 1AIL.
Mixer settings for models with two ailerons.
Finding and programming free linear and curve mixers.
Setting servo positions for radio connection faults.
Performing real-time receiver settings and retrieving sensor data.
Adjusting fundamental transmitter settings like volume, stick mode, and display.
Setting up helicopter models, including control modes and swashplate types.
Instructions for updating transmitter firmware via memory card or USB.
To Next Page