GRAUPNER mc-26

39 / 80
33028_mc_28_Teil2_jh
Note
The trim of "Elevator", "Aileron" and "Rudder" is factory-set to
"Global". This setting can, however, always be changed to "phase-spe-
cific" at any time in the "Sticks setting" menu.
Channels without delay
In this menu item, you can switch off the switching delay set in the
"Phase setting" menu for individual control channels depending on
the phase.
• Switch to the corresponding phase (this is shown in the lower left
corner of the display).
• Set the desired channel through the selection keys.
• Use the SET button to change the channel (normal / reverse)
Timers (general)
The model timer, battery timer, Timer up and Timer middle are set
here.
Model time
This timer shows the currently recorded access time to the active
model memory. If the time recording is to be switched manually, you
must assign a switch in the right column.
Through the buttons
t u or  of the right touch-pad you can
reset the timer to "0:00h".
Batt time
This timer shows the use time of the battery. The timer will be reset
as soon as the battery is fully charged. The time is added at each use
of the transmitter.
Through the buttons
t u or  of the right touch-pad you can
reset the timer to "0:00h".
Timer up and middle
These two timers are located in the upper right half of the basic dis-
play and a different name can be assigned. The function and use
mode depend on the name. Regardless of the name, the "up" and
"middle" timer can be programmed backwards or forwards as a
"timer".
Stop/motor
These two timers will start and stop with a switch, in the column "
". You can reach the column by moving the marking frame with
Phase settings
Phase trim
Annnounce
Timers (general)
Phase assignment
Non-delayed chan
Non-delayed channels
non-delay
normal
Normal
7 8 9
10
11
12
Non-delayed chan
Timers (general)
Phase timers
Wing mixers
Free mixers
MIX active/phase
Model time
Batt. time
Top:
Centr:
Stop
Log t.
Timer
–––12:34h
1:23h
0:00
0:00