41 / 80
33028_mc_28_Teil2_jh
Reset to the initial value by tapping at the same time the t u
or buttons of the right touch-pad.
Chassis
This timer is started by an assigned switch. If you want to stop the
timer, you must switch the assigned switch to the "Off" position and
press the ESC key. Reset to the initial value by tapping at the same
time the
t u or buttons of the right touch-pad.
Phase timer
In this menu you can set the timers assigned in the "Phase setting"
menu.
Timer 1 - 3
The timers are started and stopped via a switch or control switch.
Assign the switch in the column "
".
If you do not enter a value in the left column "SEL", the timer counts
up. If you set a value, the timer counts backward from this value.
In the right "SEL" column, you can specify a time at which an audible
alarm is emitted.
Lap time/Time tab
If you assign a switch or control switch here, you can stop the lap
timer with this switch. The lap time is then taken in the time table.
The basic display shows the lap counter and the lap time.
The lap counter timer can only be stopped by tapping the ESC key.
Lap display
If you assign a switch or control switch here, you can use this switch
to display the time table in the basic display.
Non-delayed chan
Timers (general)
Wing mixers
Free mixers
MIX active/phase
Phase timers
Timer1
Timer2
Timer3
Lap time/Tim teb
SEL
–––
0:00
0:00
0:00
Lap display
0s
0s
0s
–––
–––
–––
–––
SEL
GRAUBELE
#01
2:22h
T
P
«Speed »
K78
0:00.0
0:00.0
5.5V
3.9V
0:00.0
M
Lap
2:33.4
11
01
02
03
04
SEL
01:23.4
02:34.5
03:45.6
05
SEL
04:56.7
05:67.8
07
08
09
10
00:00.0
00:00.0
00:00.0
11
12
00:00.0
00:00.0
00:00.0
06
06:78.9
To Next Page
Loading...
