GRAUPNER mc-26

37 / 80
33028_mc_28_Teil2_jh
Time1
Only the times whose switch or control switch, assigned in the line
"Lap time/Time tab." of the "Phase timer" menu, is "closed" are
measured. The frequency of the switch actuation is displayed in the
basic display. This counter will be highlighted as soon as the switch
for the "Time1" timer is "open", the timer is hold (stopped).
In the stopped state, the recorded switching times can be succes-
sively read out with the selection keys.
Time2
"Time2" stores both the "Off" and "On" times of the associated
switch. Each time the switch is operated, the counting of the time
starts again and the counter is incremented by "1". The timer can be
stopped at any time via the central ESC key on the left touch panel
without actuating the switch. Actuating the switch while the stopped
timer is stopped increases the counter by 1 and restarts the "Time2"
timer.
In the stopped state, the recorded data of the "Time2" timer can be
successively read out with the selection keys.
Motor
This column is only available if in the line "Motor to CH1" of the
"Model type" menu you have set "forward" or "backward".
If you select "yes", the channel 1 on the receiver is controlled by the
CH1 control stick. The brake system in the "Wing mixer" menu is
switched off.
If you select "no", the channel 1 on the receiver is not controlled by
the CH1 control stick. The setting of the throttle position "Off" in
"Throttle min front/rear" is held. The brake system in the "Wing
mixer" menu is active and is actuated by the CH1 control stick.
Sw.time
You can reach the column by moving the marking frame with the
selection buttons  over the "Ph.timer" column to the right side.
Here you can set the switchover time to the respective phase. All
functions in the phase are switched over within the selected time.
The longer the time, the softer the switching.
Note
If individual servos are switched without delay, it is possible to set
the channels in the "Delayed channels" menu accordingly.
Brake settings
normal
Normal
Off
Pha1
Pha2
Pha3
Name Motor
Pha4
Pha5

+
+
Normal
Start
Tra c k
–
–
yes
yes
yes
yes
yes
Pha1
Pha2
Pha3
Name Sw.time
Pha4
Pha5

+
+
Normal
Start
Tra c k
–
–
0.1s
0.1s
0.1s
0.1s
0.1s