24 / 80
33028_mc_28_Teil2_jh
Switch-on warning
With this option it is possible to program the query for the position
of a switch or control so that when the transmitter is switched on in
the base display a warning will appear.
To do that you have to assign in this line a switch, a control switch or
a logical switch.
Activate a warning:
Tap on the SET button in the "Switch-on warning" line.
Move the desired switch to the position that has to be verified.
Combinations with logical switches are also possible.
If the warning is active the blue LED
WAR NING in the transmit-
ter blinks while the transmitter is switched on and the RF module
remains switched off. To deactivate the warning move the pro-
grammed switch in another position.
Deactivate the warning:
Tap on the SET button in the "Switch-on warning" line.
Tap on the Up and Down buttons of the right selection field.
In the selection field will be displayed three lines. No switch is
assigned any more.
Auto trim
With this function you can save the actually controlled position of a
model in the trim memory. The function acts on channel 2, 3 and 4
only. This function will be activated through a switch. Select the line
"Auto trim" and tap on the SET button. Move a switch in the desired
position. We recommend to select a momentary switch.
Save the position in the trim memory step-by-step:
3. Move the model to the desired position through the control
sticks.
4. Actuate the assigned switch and move the control sticks back
to the neutral position.
5. After 1 sec. the position will be saved in the trim ( ± 30%).
Note
If the auto trim function is not required any more, then we suggest
to deactivate the switch assigned to the "Auto trim function".
Thereby you avoid an accidental error function.
Timer auto reset
In this line you can select:
"Yes" - all timers, excluded model timer and transmitter operating
timer, will be set back to zero when you switch the transmitter on.
"No" - all timers hold the stand from the last use of the transmitter.
The timer will however be reset when the transmitter is switched on.
Base setup model
RF transmit ON
RF Range Test
99sec
DSC Output PPM10
Power on warning
–––
Move desired switch
to ON position
(ext. switch: SET)
GRAUBELE
01
0:01h
S
L
«normal »
K78
0:00.0
0:00.0
4.8V
4.1V
M
HoTT
! Warning !
Base setup model
RF Range Test
99sec
DSC Output PPM10
Power on warning
–––
Auto Trim
8
Base setup model
RF Range Test
99sec
DSC Output PPM10
Power on warning
–––
Auto timer reset
yes
To Next Page
Loading...
