23 24
This page shows the discharging process with parameters
and graph. Voltage and current will reach to the preset pa
-
rameters. The preset current might have limitation depending
on charge/discharge capacity and input voltage setup. Max
charge is 400W and max discharging is 60W
When to tap graph, the data view page is accessed.
The operating data is shown.
Please refer page (27~29 page 참조)
When to tap the part in red circle, Set current window
appears and, you may change the discharge current during
operating and set current window disappears when to tap X
button.
This setup is applied to the charger that is discharging and it
is not stored to memory
When to STOP button, the pop up window appears which
asks whether to stop operating. When to tap STOP or ESC
button, the charger will stop or continue the discharge
When to tap CYCLE icon on main page, you may access to cycle mode. When to tap the
data box, it is activated in blue and tap DEC/INC buttons to program the parameters
CYCLE PAGE
LiPo, Lilon, LiFe, NiCd, NiMH, Pb batteries cycle page
Tap CYCLE icon at main page to
access to cycle mode
Tap the part in red circle then it is activated in blue and can be
programmed. The applied parameters of charge/discharge current
came from Charge and Discharge mode
When to tap Enter button, the next page is accessed.
1)It is the operating sequence of cycle mode
C > D - Discharge after charge
D > C - Charge after discharge
D:C > D - 1 time discharge: Discharge after charge
2)Cycle -
The number of operating cycle setup ( 1~10 times)
3)C->D Delay - Time interval setup after charge (1~30min)
4)D->C Delay - Time interval setup after discharge (1~30min)
The parameters of charge, discharge came from Charge
and Discharge mode The charge/discharge current can
be changed at Charge and Discharge mode
LiPo, Lilon, LiFe, NiCd, NiMh, Pb batteries cycle process
The charger checks whether balance board is connected.
It is automatic process
USER NAME
To Next Page
Loading...
Need help?
General
