5 6
◎ BOX CONTENTS
◎ SAFETY PRECAUTIONS
- Do not attach the charger to both the AC and DC power sources at the same time.
- Never connect the input jack (DC input) to the AC power.
- Disconnect the docking power supplier while connecting the DC power source to the rear
terminal of the charger.
- Program the input power setup correctly during the USER SETUP.
- During the USER SETUP, program the correct settings for the docking power supplier.
- CAUTION: Using an automobile battery as a power source can result in a complete discharge/
draining of the automotive battery.
- Supply sufficient power to the charger. The charger output has a maximum of 400W for each
channel.
1. Charger
2. 7 Cells Balance board/Cable (EH to XH)
3. Temperature sensor (2pcs)
4. USB cable
5. Output cable with alligator clip (2 pairs)
6. Charger rack (optional)
7. User manual
8. Warranty card
- If possible, place the battery in a safety bag during the charging or discharging process.
- Pay attention to the charger during use. Do not leave the charger unattended.
- If the charger becomes hot, disconnect the battery and remove the input power immediately.
Allow the charger and the battery to completely cool down before reconnecting.
- Do not attempt to charge dead or damaged batteries.
- Use identical batteries in the charger.
- Do not attempt to charge a battery pack containing different types of batteries.
- Do not use a too short or damaged cables.
- Ensure that each channel has a completely charged pack.
- Do not use near a flammable object. Use only in well-ventilated areas. Explosive gases may
be generated during the operation of this product.
- Do not reverse the positive and negative terminals. An incorrect connection will damage the
batteries and may cause damage to the charger.
- Use only rechargeable batteries that meet the product specifications of this charger.
- Do not allow water, moisture or foreign objects into the charger.
- Do not use in humid locations. Do not operate with wet hands.
- Do not attempt to dismantle the charger.
- Do not use on fleecy materials, such as carpets, blankets, beds and cushions.
Use on hard flat surfaces.
- Do not use in the extreme cold or heat, as the charger may not operate using the expected
values, causing failures in the operation.
- Use in a well-ventilated location. Do not block the cooling fan (rear) and the air inlet (front).
- Ensure that the TFT panel is visible during the operation of this product.
The TFT panel might not be visible under direct sunlight.
- We strongly recommend balancing Lithium packs. An unbalanced pack can cause damage
and, in extreme cases, can cause a fire.
To Next Page
Loading...
Need help?
General
