The transmitter must be set to „OFF“ and left in that state for the whole period of the charge process!
Never switch a radio control transmitter on when it is still connected to the battery charger.
Never attempt to carry out any battery discharge or battery maintenance programs via the transmitter’s integral charge socket. The charge socket
is not suitable for this purpose.
When you set a particular current for charging, the charger only supplies that current if the value does not exceed the unit’s technical capacity! If
you set a charge current which the charger cannot deliver because it falls outside its technical limits, the unit automatically reduces the current to
the maximum possible value. In this case the screen displays the charge current which is actually fl owing.
Liability exclusion
As manufacturers, we at GRAUPNER are not in a position to ensure that you observe the correct methods of operation when installing, using and maintai-
ning this charger. For this reason we are obliged to deny all liability for loss, damage or costs which are incurred due to the incompetent or incorrect use
and operation of our products, or which are connected with such operation in any way
.
6. Cleaning and maintenance
7. Box contents
P
The
1. Charger
2. 7 Cells Balance board/Cable (EH to XH 2 pairs)
3. Temperature sensor (2pcs)
4. USB cable
5. Output cable with alligator clip (2 pairs)
6. Input cable
7. User manual
8. Warranty card
charger is entirely maintenance-free in use, and requires no servicing of any kind. However, it is in your own interests to protect the unit
from dust, dirt and damp!
P
To clean the charger, disconnect it from the car battery and any other battery, and wipe it clean with a dry cloth (don’t use cleaning agents!)
8
Operating Manual ULTRA DUO PLUS 80
To Next Page
Loading...
Need help?
General
