To Next PageTo Next Page
Need help?Do you have a question about the GRAUPNER ULTRA TRIO PLUS 14 and is the answer not in the manual?
General| Brand | GRAUPNER |
|---|---|
| Model | ULTRA TRIO PLUS 14 |
| Category | Battery Charger |
| Language | English |
Covers product use, environment, power, ventilation, and modifications.
Covers incompatible batteries, polarity, and short circuit prevention.
Covers pre-charge checks, intermittent contacts, and overcharging risks.
Explains charge quantity, rapid charging, and standard charge current.
Details on charging transmitter batteries, including bypass diode and removal.
Explains how the charger handles currents exceeding its limits.
Illustrates and lists recommended charge leads and their connectors.
Identifies power inputs, balancer connectors, and charge outputs on the unit.
Explains the function of the INC, DEC, MODE, and ENTER buttons.
Details the four program groups for Ni-Cd, Ni-MH, Lithium, and Lead-acid batteries.
Explains how to switch between NiCd, NiMH, Lithium, and Pb program groups.
Guides through language selection and initial settings like safety timer and buzzer.
Indicates when the charger is ready for use after initial setup.
Instructions for connecting battery leads and balancer connector with polarity checks.
Critical steps for setting Lithium battery type and cell count to avoid damage.
How to start the charge or discharge process and how to interrupt it.
Steps for connecting batteries and balancer to outputs 2 and 3.
Importance of correctly setting Lithium battery cell count for safe charging.
Initiating the charge or discharge process for outputs 2 and 3.
Automatic Ni-Cd charging, detecting type and adjusting current.
Manual Ni-Cd charging using a set charge current.
Discharging Ni-Cd packs to determine residual capacity or a set level.
Automatic Ni-MH charging, detecting type and adjusting current.
Highlights the dangers of overcharging/discharging Lithium batteries and safety precautions.
Lists the available Lithium program types: Manual, Discharge, Storage, Type Select.
Manual charging of lead-acid batteries with a settable maximum charge current.
Details the information shown on the two-line liquid-crystal screen.
Explains how the charger monitors limits and switches off if critical values are exceeded.
Shows the 'BATTERY CHECK WAIT PLEASE' message before initiating a charge.
Messages for car battery status, polarity, and contact issues.
Messages for time expiration and battery voltage discrepancies.
Information on downloading USB drivers and PC software for the charger.
Challenges with small cell counts and termination reliability.
Advice on battery performance, charging, soldering, and storage.
Precautions against overheating, short-circuits, gas, and disposal.
Details charge/discharge currents, power, cell counts, and capacities for each output.
Covers voltage ranges, max power, PSU requirements, and dimensions.
Guidance on proper disposal of the product and batteries.
Details claim procedures, proof of purchase, and warranty duration.
