EN - 27
BATTERY
Unit comes equipped with a maintenance-
free battery that requires no regular
maintenance except cleaning the terminals.
Remove Battery
(Figure 13)
1. Shut OFF engine. Engage parking
brake. Remove the ignition key.
2. Place seat in the service position (See
Seat Adjustments on page 18).
3. Disconnect cables from battery
(negative, then positive).
4. Remove hold down and remove battery.
Replace Battery
(Figure 13)
1. Replace battery and secure with battery
hold down.
2. Reconnect cables to battery (positive,
then negative). Position boot over
positive terminal.
3. Return seat to operating position.
Clean Battery
Keep battery and its terminals clean. Inspect
every 100 operating hours or monthly for best
performance.
1. Remove battery from unit. See Remove
Battery on page 27.
2. Clean terminals and battery cable ends
with wire brush.
3. Coat terminals with dielectric grease or
petroleum jelly.
4. Replace battery. See Replace Battery on
page 27.
Charging the Battery
Battery Electrolyte First Aid
Follow First Aid directions for contact with
battery fluid.
• External Contact: Flush with water.
• Eyes: Flush with water for at least 15
minutes and get medical attention
immediately!
WARNING: AVOID INJURY. Read
and understand entire Safety section
before proceeding.
WARNING: Battery posts, terminals
and related accessories contain lead
and lead compounds, chemicals
known to the State of California to
cause cancer and reproductive harm.
Wash hands after handling.
Figure 12
DO NOT Sharpen to This Pattern
Sharpen to This Pattern
DISCARD if More Than
1/2" (1.27 cm)
1
1
4
2
4
3
1. Cutting Edge
2. Square Corner
3. Air Lift Erosion
4. Air Lift
Figure 13
1. Negative terminal
2. Positive terminal
3. Battery
4. Hold Down Bracket
2
3
1
4
To Next Page
Loading...
