Gravely Pro-Turn 252 - Check Parking Brake; Clean Battery

EN - 28
Install Blades
See Figure 29.
1. Secure lower spindle guards and blades
to spindles with one bevel washer and
hex bolt. Torque to 156 – 217 N•m
(115 – 160 lb-ft).
2. Reconnect spark plug wires.
CHECK PARKING BRAKE
IMPORTANT: Check brake on both sides of
unit.
1. Place unit in service position. See
Service Position on page 23.
See Figure 31.
2. Measure length of compression spring
and distance between the stop nut and
trunnion. Compression spring length
MUST be 3.8 cm (1 1/2") and the gap
between stop nut and trunnion MUST be
3.2 – 6.4 mm (1/8 – 1/4").
• If measurements are outside
specification, adjust parking brake. See
Adjust Parking Brake on page 34.
• If measurements are within
specification, no adjustment is needed.
3. Return seat to operating position.
CLEAN BATTERY
Remove Battery
See Figure 32.
1. Place unit in service position. See
Service Position on page 23.
2. Disconnect the negative cable and then
the positive cable from battery.
3. Remove wing knobs securing hold-down
bracket to battery and remove bracket.
4. Remove battery.
Clean Battery
1. Clean terminals and battery cable ends
with a wire brush.
2. Coat terminals with dielectric grease or
petroleum jelly.
Install Battery
1. Install battery and secure with hold-down
bracket and wing knobs.
CAUTION: Mating surfaces
between spindle, lower spindle
guard, blade and washer MUST
be free of debris to ensure
correct tightness and alignment.
Figure 31
WARNING: AVOID INJURY.
Battery posts, terminals and
related accessories contain lead
and lead compounds, chemicals
known to the State of California
to cause cancer and
reproductive harm. Wash hands
after handling.
Figure 32
1. Battery
2. Wing Knob
3. Hold-Down Bracket
4. Positive Battery Cable
5. Negative Battery Cable
3
2
4
5
1