CCT10/CCT20 USER MANUAL
8
Accumulate weight and count. The piece weight window briefly shows
-r01-- -- . The scale can accumulation up to 99 times. In the setup mode, it
means enter (confirmation).
Display total accumulated count,total accumulated weight, and total count.
Clear accumulation：press and hold the【MR】key until buzzer beeps
twice, then clear accumulation
Save piece weight into memories
Press this key and one of memory keys (M01-M40) to save the current
piece weight. In addition, you can also use 0~9 number key and decimal
【.】key to manually enter piece weight, and then press the【PCS WT
MEM】key, followed by one of memory keys. To recall the memories, just
press the memory keys (M01-M40) you have saved before.
Clear the piece weight window. In the setup mode, it means exit.
Select piece weight memory range. P1: M01 to M20, P2: M21-M40. On
LCD display, the current selected range is indicated by ◄
User Functions (UF1 -- UF9)
At weighing mode，press and hold the【T】key，then press the【M+】key，weight
window will show UF-1，press【T】key or【Z】key to cycle select UF-1~UF-8
Table: List of User Functions
Press 【M+】key to enter，weight window displays
internal value (SPAN)，piece weight window displays
battery actual voltage, total count window displays
internal value(zero), Press【CE】key to exit
To Next Page
Loading...
