Gravity Measurement CCT10 - Page 9

CCT10/CCT20 USER MANUAL
9
UF-2
Piece weight auto-
average
Press 【M+】key to enter，display AAuG 1 (default
factory setting）， Use 0 and 1 keys to enable or disable
auto-average function, Press 【M+】key to confirm，
press 【CE】key to exit
AAu G 0 ：Disable A A u G 1 ：Enable
UF-3
Auto power-off
Press【M+】key to enter，A o F F 0 0 (factory default,
00 means auto power-off is off). Use 0~9 keys to enter
auto power-off time in minutes. Press the【M+】 key to
confirm，press【CE】key to exit。
UF-4
Backlight
Press【M+】key to enter. Use 0 ~2 keys to select
backlight mode
L i t 0 ：Auto (factory default)
L i t 1 ：backlight on
L i t 2 ：backlight off。
Press 【M+】key to confirm, Press 【CE】key to
exit。
UF-5
Accumulation
Press【M+】key to enter. Use 0~2 keys to select
accumulation conditions. Press the 【M+】 key to
confirm：
A C C U 0 0 (factory default)
AB
A: 0--- Stable required
A: 1--- Stable not required
B: 0---The weight has to return to zero to accept next
accumulation
B: 1--- The weight does not have to return to zero to
accept next accumulation
B: 2-- No tare weight to accept next accumulation
Press 【M+】key to confirm. Press 【CE】key to exit
UF-6
RS-232 output
Press【M+】key to enter. Use 0~4 keys to enter RS232
output formats.
232 30 (factory default)
AB
A: Baud rate setup
0：1200 1：2400 2：4800 3：9600 4：19200
B：Output mode setup
0：RS232 output disable 1：Manual output (formats
2
Press 【M+】key to confirm. Press 【CE】key to exit
UF-7
A/D update rate
Press【M+】key to enter. Use 0~2 keys to enter ADC
speed: