GREAT VIGOR Cage - Throttle and Brake Linkages Mounting

! Make sure the servo is in the neutral position.
First through the Brake linkage into the brake
pin, Install the servo arm to the servo and
tighten the retaining screw. Then, push the
ball end onto the engine carburetor ball stud.
10mm
Step 37
Retaining Screw
(Included with Servo)
Throttle and Brake Linkages Mounting
Step 38
Step 35
32mm
38A - Grub Screw w/Threadlock 3x3mm -- 2
38A