46
Cloning the Programmed Data
You can transfer the programmed data to and from another PSR-300 (or PSR-
400) scanner using an optional connecting cable with 1/8-inch (3.5 mm) stereo
phone plugs on both ends (not supplied).
Note: CLONE MODE Incorrect Model appears if the scanner receives data
from another scanner other than a PSR-300 (or PSR-400).
Follow these steps to clone the data.
1. Turn on both scanners.
2. Connect the connecting cable to each scanner’s PC/IF jack. ** CLONE
MODE ** Press UP to send Remove cable to exit. appears.
3. Press . Confirm to send data? 1 -> YES Press other key for NO. ap-
pears.
4. Press 1 to send the data to the other unit or press any other key to cancel
the operation.
The scanner sends the data. To exit the clone mode, remove the cable.
To Next Page
Loading...
