Grecom PSR-300 - Programming 800;900 MHz Motorola Trunking; 800;900 MHz Motorola Programming

50
If you try to program an offset frequency in the UHF-Hi bands (806-960 MHz),
the scanner ignores the entry.
Follow these steps to program Motorola trunking frequencies in the UHF-Lo
band:
1. Press PGM then TRUNK to enter the ID program mode.
2.Press FUNC and press (or hold) or to select the bank.
3. Press MODE and select MOT.
4. Press FUNC then 2. The display indicates Custom Range 1/3 on second
line, Base: 406.0000 on the third line, Offset: 380 on the fourth line and
Step: 25.00kHz on the bottom line.
5. When B in Base blinks, if necessary, press the desired Base frequency with
the number keys and press ENT. Confirm the entry. If it is incorrect, press
the number keys again to set the base frequency. After you confirm the
input, press ENT again.
6. While O in Offset blinks, if necessary, enter the offset number and press
ENT. Confirm the entry. If it is incorrect, then press the number keys again to
set the frequency. After you confirm the input, press ENT again.
7. While S in Step blinks, repeatedly press or to select the step number,
5.0, 6.25, 10.0, 12.5, 15.0, 18.75, 20.0, 25.0, 30.0, 31.25, 35.0, 37.5, 40.0,
43.75, or 50.0 kHz, then press ENT.
8. Press PGM to enter the program mode. Store the trunking IDs into the sub-
bank in the same bank.
Programming Motorola Trunking Systems (800/900 MHz)
Follow these steps to program 800/900 MHz band Motorola trunking.
Notes:
• On the 800 MHz trunking band, you can select a base frequency (normal or
offset).
• On the 900 MHz trunking band, you do not need to set the base frequency
(base, offset, step).
1. Press PGM then TRUNK to enter the ID program mode.
2. Press FUNC then or to select the desired bank.
3. Press MODE and select Motorola trunking mode.
4. Press FUNC then 3. Use Up/Down keys to set 800 MHz Motorola ch plan
NORMAL appears.
5. Press or to select NORMAL or SPLINTER and press ENT.