Gree FGR30Pd/DNa-X - Page 8

GREE Duct type split Air conditioner Inverter Series
6
No.
Symbols
Instructions
3
It's valid under Save mode and displays during setting process.
Temperature lower limit for Cooling: Limit the minimum temperature value
under Cooling or Dry mode.
Temperature upper limit for Heating: Limit the maximum temperature value
under Heating, Space Heating or 3D Heating mode.
4
*
Auto mode (Under Auto mode, the indoor units will automatically select their
operating mode as per the temperature change so as to make the ambient
comfortable).
5
It shows the setting temperature value(In case the wired controller is
controlling a Fresh Air Indoor Unit, then the temperature zone will display
FAP).
6 Cooling mode.
7 Dry mode.
8 Fan mode.
9 Heating mode.
10
When inquiring or setting project number of indoor unit, it displays "NO."
icon.
11
*
Floor Heating mode (When Heating and Floor Heating simultaneously shows
up, it indicates 3D Heating is activated).
12 Display "SET" icon under parameter setting interface.
13
- *
Space Heating mode.
14 Display "CHECK" icon under parameter view interface.
15
Outdoor unit operates under Save mode/upper limit of system capacitor less
100%/remote Save status.
16 Sleep status.
17
Current set fan speed (including auto, low speed, medium-low speed,
medium speed, medium-high speed, high speed and turbo seven status).
18
*
Air status, Indoor unit optional function.
19 Remind to clean the filter.
20 Quiet status (including Quiet and Auto Quiet two status).
21
*
Allow auxiliary electric heating On icon.
22 Light On/Off function.
23 X-fan function.
24
*
Health function, Indoor unit optional function.
25
*
Reserved function.
26 Out function.
27 Outdoor unit defrosting status.
28 Gate-control function.
29 Shielding status.
30 Child Lock status.