fig. 1 fig. 2 fig. 3
12
Clean and Maintenance
Warning:
● Before cleaning, turn off the dehmidifier and disconnect the power.
Otherwise, it may lead to electric shock.
.
Otherwise it will damage unit's appearance.
1. Grille and Case
To clean the case:
When there is dust on the case, use soft towel to dust it
off; When the case is very dirty(greasy), use mild
detergent to clean it.
To clean the grille:Use a dust catcher or brush.
1. Remove panel
Open the clasps at both sides of lower side of
panel, open the panel as shown in fig ①, and
open it to 20º. Do not open it forcibly or open
the angle too large. As shown in fig ②, pull up
the panel to remove it.
2. Remove air filter
As shown in fig ③, pull the clasps of air filter
outwards to remove the air filter.
2. Air Filter
4. Install air filter
a.Insert the lower end well (fig. 1)
b.Insert the clasps at both sides of lower end well (fig. 2)
c.Insert the clasps at both sides of upper end well (fig. 3)
3. Clean air filter
Clean the filter in warm, soapy water.
Rinse it and let the filter dry before replacing it.
②
①
③
To Next Page
Loading...
