DC Inverter Multi VRF System User Manual
24
Fuse or circuit breaker is cut off.
Replace fuse or reset the circuit
breaker.
Restart unit when power is
restored.
Remote controller’s power is not enough
Remote controller is out of the control range.
Control range is within 8m.
Unit runs but stops
immediately.
Air inlet or air outlet of indoor and outdoor units is
blocked.
Abnormal cooling or
heating
Air inlet or air outlet of indoor and outdoor units is
blocked.
Adjust setting at remote
controller or wired controller
Fan speed is set too low.
Adjust setting at remote
controller or wired controller
Wind direction is not correct.
Adjust setting at remote
controller or wired controller
Close the door or window.
Too many people in the room.
Too many heat resources in the room.
Filter is blocked and dirty.
●Note
If problem cannot be solved after checking the above items, please contact Gree service
center and describe the cases and models.
●Following circumstances are not malfunctions.
Unit starts up immediately after it is
turned off.
Overload protection switch makes it run after a
3-min delay.
Standby operation lasts for about 1min.
Mist comes from
the unit.
Indoor air with high humidity is cooled rapidly.
Slight cracking sound is heard when unit
is just turned on.
It is the noise when electronic expansion valve is
initialized.
There is consecutive sound when
cooling.
It is the sound for gas refrigerant flowing in the
unit.
There is sound when unit starts or stops.
It is the sound when gas refrigerant stops
flowing.
There is slight and consecutive sound
when unit is running or after running.
This is the sound of drainage operation.
Cracking sound is heard when unit is
running or after running.
This is the sound caused by the expansion of
panel and other parts of the unit due to
temperature change.
Unit starts up after not operating for a
long time.
Dust in indoor unit is blown out.
Unit absorbs the room odor and then blows it
out.