GREE DC Inverter Side Discharge VRF Ⅱ for North America
49
Take indoor unit as an example. Click “IDU Settings” and a dialog box will pop up.
Tick the indoor units that need setting in the IDU selection zone or you may click “Select All” to
select all of them or “Select Inverted” to select none of them. After selection, the current values of the
corresponding parameters will be displayed in the zone of settings. Click “Set” and then click in the
pop-up dialog box to select values. Click “Set” and then the corresponding order will be sent to units. If
setting is successful, it will be displayed at the current values.
To Next Page
Loading...
Need help?
General
