Gree GMV-ND22C/A-T - Engineering Application Functions Operated through the YAP1 F Remote Controller

GREE GMV5 INDOOR UNIT SERVICE MANUAL
85
5.5 Engineering Application Functions Operated through the
YAP1F Remote Controller
The YAP1F remote controller only provides engineering application functions for setting the master
IDU. For other user operation functions, refer to the “Remote Controller Operating Instructions”.
The method for setting the master IDU through the YAP1F remote controller is as follows:
No.
Button name
Function
1
ON/OFF
Turn on or turn off the unit
2
TURBO
Set turbo function
3
MODE
Set operation mode
4
Set up&down swing status
5
I FEEL
Set I FEEL function
6
TEMP
Switch temperature displaying type on the unit’s display
7
Set health function and air function
8
LIGHT
Set light function
9
X-FAN
Set X-FAN function
10
SLEEP
Set sleep function
11
CLOCK
Set clock of the system
12
TOFF
Set timer off function
13
TON
Set timer on function
14
Set left&right swing status
15
FAN
Set fan speed
16
/
Set temperature and time
(For details about the above figures, refer to the instructions 66174100016.)
Perform settings by pressing “▲” and “▼” in air supply mode:
① Set the temperature to 30°C.
② Press “▼” and then “▲” in five seconds. Repeat this operation for three times.
③ After successful settings, “UC” is displayed on the receiving indicator panel of the remote
controller for five seconds and”MASTER” is displayed on the wired controller.