ERV+DX coil
15
single branch line so that the single-core wire can be exposed.
2) Remove the wiring screws on the patch board.
3) Shape the tail of wire into ring by needle nose pliers, and keep the gauge
of
ring in accordance with screw.
4) Lead the screw across the circle of the single branch line and fix it on the
wiring board.
(2) Connection of multi-twisted wires
1) Use a wired stripper to strip away about 10mm of the insulation layer at the
end of multi-twisted wire.
2) Remove the screws on wiring board.
3) Use a round terminal fastener or pliers to securely fasten the round
terminal
with each core wire of the multi-core wire.
4) Confirm the position of each core wire on the round terminal and then use
a
screwdriver to tighten the terminal screw.
Unit: mm
Connection of Power Cord:
1) The unit must be installed with circuit breaker independently which is used
for short circuit protection and overload protection. The circuit breaker shall
be closed in normal times.
2) During operation, all outdoor units, fresh air units and outdoor units in the
same system must be kept energized. Otherwise, the system cannot operate
normally.
To Next Page
Loading...
