108
7.2 Select installation position of ODU
Conditions for selecting the installation position
(1) Install the unit at a place where is adequate to withstand the weight of the unit and make sure the unit
would not shake or fall off.
(2) Fully consider the influence of strong winds, typhoons and earthquakes when selecting the installation
site, and strengthen the installation.
(3) The influence of flammable, explosive, corrosive gases or exhaust gases should be avoided.
(4) Ensure that there is a certain space for heat exchanging and maintenance, so that the ventilation is
smooth and the running is reliable.
(5) Outdoor units and indoor units should be as close as possible to minimize the length and angle of the
cooling pipes.
(6) Do not allow children to approach the unit. Preventive measures should be taken to prevent children
from contacting the unit.
(7) The unit should not be installed in places with high environmental pH or high voltage fluctuations, and
places such as vehicles and ships.
(8) Do not install the unit at the place where is close to the equipment that generates electromagnetic
waves. Electromagnetic waves can affect the control system and cause fault.
To Next Page
Loading...
