Air-to-water Heat Pump
1
MONOBLOC
TYPE
Safety Notices (Please be sure to abide )
 
WARNING
: 
If not abide strictly, it may cause severe damage to the unit or the 
people.
 
NOTE
: If not abide strictly, it may cause slight or medium damage to the unit or the 
people.
 This sign indicates that the operation must be prohibited. Improper operation may 
cause severe damage or death to people
 This sign indicates that the items must be observed. Improper operation may 
cause damage to people or property.
 NOTE
After receipt of the unit, check it for appearance, unit model compared with your desire 
and attachments.
Design and installation work of the unit must be performed by authorized personnel 
according to applicable laws and regulations and this Instruction.
After installation work, the unit cannot be energized unless there is not any problem in 
check.
Ensure periodical clean and maintenance of the unit after normal operation of the unit 
for longer life and reliable operation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service 
agent or similarly qualied persons in order to avoid a hazard.
The appliance shall be installed in accordance with national wiring regulations.
This product is a kind of comfort air conditioning, and is not allowed to be installed 
where there are corrosive, explosive and inammable substances or smog; otherwise 
it would lead to operation failure, shortened service life, five hazard or even severe 
injuries. Special air conditions are required for where mentioned above.
Correct Disposure
This marking indicates that this product should not be 
disposed with other household wastes throughout the EU.To 
prevent possible harm to the environment or human health from 
uncontrolled waste disposal,recycle it responsibly to promote the 
sustainable reuse of material resources. To retuern your used 
device,please use the return and collection systems or contact 
the retailer where the product was purchased. They can take this 
product for environmental safe recycling.
R32:675