Gree GUD50PS/A-T - Page 120

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
115
Removal of fan and motor
Note: Before removing the motor, power must be cut off.
Step
Picture
Work instruction
5. Remove the fan.
●Use a screwdriver to remove
the clamping band of motor.
Then remove the fan.
6. Remove motor.
●Use a screwdriver to unscrew
the 4 screws of motor. Then
remove the motor.
7. Replace and install the
motor.
●Remove the motor from motor
support and then replace with a
new motor.
●Tighten the 4 screws of motor
with a screwdriver.
8. Install the fan.
●Direct the hole of fan to the
motor shaft and then mount on
the fan.
●Tighten the clamping band of
motor with a wrench.