Gree GUHD series - Page 145

80DWFK6HULHV'&
,QYHUWHU6HUYLFH0DQXDO
142
5. Loosen the
back side plate
/RRVHQWKHVFUHZV¿[LQJWKH
back side plate.
6. Remove the
backside plate
Remove the back side plate.
Removal and Installation of Gas-liquid Separator and Compressor
Remark: Before removing the compressor, make sure that there is no refrigerant inside the pipe system and that the
power has been cut off.
Step Illustration
Handling Instruction
1. Remove power
connecting wire of
compressor
A. Loosen the power box cover of the
compressor.
B. Pull out the power connecting wire
of the compressor.
C. Remove the power insert of the
compressor