Gree GUHD series - Page 146

80DWFK6HULHV'&
,QYHUWHU6HUYLFH0DQXDO
143
2. Remove the
screw fixing
the gas-liquid
separator
Remove the screw fixing the gas-
liquid separator.
3. Remove the
inlet pipe and
outlet pipe of gas-
liquid separator
A. Unsolder the inlet pipe and outlet
pipe of the gas-liquid separator.
B. During soldering,charge nitrogen
with pressure of 0.5±0.1kgf/cm
2
(relative pressure)
C. Do not burn the surrounding
material during heating.
4. Remove
the gas-liquid
separator .
Remove the gas-liquid separator.
5. Remove the
screws fixing the
compressor .
Remove the screws fixing the
compressor .
6. Remove the air
inlet pipe and the
outlet pipe of the
compressor
A. Unsolder the inlet pipe and outlet
pipe of the gas-liquid separator.
B. During soldering,charge nitrogen
with pressure of 0.5±0.1kgf/cm
2
(relative pressure)
C.Do not burn the surrounding
material during heating.