Gree GUHD series - Page 147

80DWFK6HULHV'&
,QYHUWHU6HUYLFH0DQXDO
144
7. Remove the
compressor .
Remove the compressor from the
compressor support.
8. Install a new
compressor on
the compressor
support.
A. Put a new compressor in the right
place.
B. Tighten the nuts fixing the
compressor. C. The compressor
should not be up-side down.
9. Connect the
pipes of the
compressor to the
system .
A. Weld the pipes of the compressor.
B.During soldering, charge nitrogen
with pressure of 0.5±0.1kgf/cm
2
(relative pressure)
C.Do not burn the surrounding
material during heating.
10. Install a gas-
liquid separator
DQG¿[LW
A. Put the gas-liquid separator in the
right place.
%7LJKWHQWKHVFUHZV¿[LQJWKHJDV
liquid separator and the isolation
sheet.