Gree GUHD series - Page 162

80DWFK6HULHV'&
,QYHUWHU6HUYLFH0DQXDO
159
Remove panel parts
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly. Do not
scratch the outer parts.
Step Illustration Handling Instruction
Remove
panel parts
Ɣ5HPRYHWKHVFUHZVVKRZQE\WKH
arrow in the graph with screwdriver
(two on both right and left and 4 in
the front) and then remove the panel
parts.
Remove sub-assy of electric box
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly,
especially the components inside the box in case of water and hit.
Step Illustration Handling Instruction
1. Remove
electric box
cover
Ɣ5HPRYHVFUHZVDVVKRZQE\
the arrow in the graph on left and
remove the electric box cover.
5HPRYHDLUGHÀHFWLQJSODWHPRGXOHV
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly,
HVSHFLDOO\WKHMRLQWVRIWKHDLUGHÀHFWLQJSODWH
Step Illustration Handling Instruction
Remove sub-
assy of air
deflecting
plate
Ɣ5HPRYHWKHDLUGHIOHFWLQJ
plates from the air deflecting
plate support assembly, and then
remove both ends from the air
sweeping motor joint. (As is shown
in the graph, arrow represents the
support assembly and circle the air
sweeping motor joint.)
Remove water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly.
Step Illustration Handling Instruction
Remove water-
containing plate
modules
Ɣ5HPRYHWKHZDWHU
containing plate modules.