+ / - button
This function is only available for some models.
●
NOTE
I Feel button
●
●
●
no display
(horizontal louvers stops
at current position)
Press "Wifi" button to turn on WiFi function, "Wifi"
icon will be displayed on the remote controller;
Hold "Wifi" button for 5s to turn off WiFi function
and "Wifi" icon will disappear.(This function is only
available for some models.)
Under off status, press "Mode" and "Wifi" buttons
simultaneously for 1s, WiFi module will restore
factory settings.
Press " + " or " - " button once increase or decrease
set temperature 1℃(℉). Holding " + " or " - " button,
2s later, set temperature on remote controller will
change quickly. On releasing button after setting is
finished, temperature indicator on indoor unit will
change accordingly.
●
●
NOTE
UD-swing button
Press this button can select up & down swing angle.
Fan blow angle can be selected circularly as below:
(blink 5s)
humidity control
with cooling mode
cooling mode
smart dehumidification
general
with cooling mode
When selecting " ", air conditioner is blowing
fan automatically. Horizontal louver will automat-
ically swing up & down at maximum angle.
When selecting " 、 、 、 、 " , a ir condi-
tioner is blowing fan at fixed position. Horizontal
louver will stop at the fixed position.
Under cooling mode, press this button can select
humidity control with cooling mode, smart dehu-
midification with cooling mode, and general cooling
mode, and they can be set to operate circularly.
●
The humidity for smart dehumidification is auto-
matically adjusted according to human body
●
When humidity control with cooling mode is set,
Press this button continuously more than 2s, the main
unit will swing back and forth from up to down, and
then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immedi-
ately.
Under swing up and down mode, when the status is
switched from off to , if press this button again 2s
later, status will switch to off status dir
ectly; if
press this button again within 2s, the change of swing
status will also depend on the circulation sequence
stated above.
general
humidity control with
dehumidification mode
dehumidification
mode
the remote controller will display " " , and
humidity value "88" and "%" icon will blink for 5s;
you can press "+" and "-" buttons to set the
humidity value within 5s.
Under humidity control with cooling mode,
humidity setting range for the remote controller:
40%-80%.
Temperature can be adjusted under humidity
control with cooling mode.
continuous dehumidification
comfort; no need to set the humidity manually.
Under dry mode, press this button can select
humidity control with dehumidification mode, con-
tinuous dehumidification mode, general dehumidifi-
cation mode, and they can be set to operate circu-
larly.
●
When smart dehumidification with cooling mode
●
with
dehumidification mode
is set, the remote controller will display " " ;
the remote controller and indoor unit will display
"Ao" for 5 seconds.
Temperature can be adjusted under smart dehu-
midification with cooling mode.
When humidity control with dehumidification mode
is set, the remote controller will display " ", "%"
Wifi button
Humidity button
Hold " " button above 2s to set your required
swing angle. When reaching your required
angle, release the button.
Press this button to start I Feel function and " "
will be displayed on the remote controller. After
this function is set, the remote controller will send
the detected ambient temperature to the controller
and the unit will automatically adjust the indoor
temperature according to the detected tempera-
ture.Press this button again to close I Feel func-
tion and " " will disappear.
Please put the remote controller near user when
this function is set. Do not put the remote control-
ler near the object of high temperature or low tem-
perature in order to avoid detecting inaccurate
ambient temperature. When I Feel function is
turned on, the remote controller should be put
within the area where indoor unit can receive the
signal sent by the remote controller.
To Next Page
Loading...
