Gree GWH18YE-S6DBA2A - Function and Control; Remote Controller Introduction for YAG1 FB3(Wifi)

46
Technical Information
Service Manual
6. Function and Control
6.1 Remote Controller Introduction for YAG1FB3(WiFi)
Buttons on remote controller
-
+
FAN
MODE
ON/OFF
FAN
TURBO
MODE
ON/OFF
SLEEPQUIETLIGHT WiFi
TEMP I FEEL
CLOCK
TIMER ON TIMER OFF
(before opening cover) (after opening cover)
Buttons on remote controller
8ȭ heating function
Scavenging function
Set time
X-FAN function
Light
Set temp.
Outdoor ambient
temp.
Indoor ambient
temp.
Sleep mode
Clock
Health mode
I feel
Quiet
TIMER ON / TIMER OFF
Auto mode
Cool mode
Dry mode
Fan mode
Left & right swing
Up & down swing
Child lock
Send signal
Turbo mode
Heat mode
Operation mode
Set fan speed
Temp.
display type
Set temperature
WiFi function
Introduction for buttons on remote controller
NOTICE:
● This is a general use remote controller. It could be used for
the air conditioner with multifunction. For the functions which the
model doesn't have, if press the corresponding button on the
remote controller, the unit will keep the original running status.
● After putting through the power, the air conditioner will give
out a sound. Operation indicator " " is ON. After that, you can
operate the air conditioner by using remote controller.
● Under on status, pressing the button on the remote controller,
the signal icon " " on the display of remote controller will blink
once and the air conditioner will give out a "di" sound, which
means the signal has been sent to the air conditioner.
● Under off status, set temperature and clock icon will be
displayed on the display of remote controller (If timer on, timer
off and light functions are set, the corresponding icons will be
displayed on the display of remote controller at the same time);
Under on status, the display will show the corresponding set
function icons.
1.
ON/OFF
button
Press this button to turn on the unit. Press this button again to
turn off the unit.
2.
FAN
button
Press this button, Auto, Low, Medium-low, Medium, Medium-
high, High speed can be circularly selected. After powered on,
auto fan speed is default. Under dry mode, low fan speed only
can be set up.
ATUO
Medium fanLow fan
High fan
Medium-low fan
Medium-high fan