Gree GWHD(24)ND3CO

INSTALLATION OF POWER AND WIRING
Step 9
Outdoor Unit Wire Connections
Disconnect all electrical power to unit including disconnects,
fuses and breakers.
1. Remove the service panel on right side of the outdoor unit.
2. Insert interconnecting wires and main power wires
through the wire holes on conduit mounting bracket.
3. Secure main power conduit (and interconnecting
wire conduit, if required) with locking nuts to
conduit mounting bracket
4. Open wire clamp/strain relief and adjust wire
lengths for proper connections to the outdoor unit
terminal block.
5. Following the same wire color and terminal references
from the indoor unit, tightly connect each interconnecting
wire to the terminal block per wiring diagram below.
NOTE: Crossing interconnecting wires will cause system malfunction and possible damage.
WARNING
Multiple Port Cable
Connections
(Reference Only)
Multiple Port Conduit
Mounting Panel
(Reference Only)
Main Power Wires
20
Interconnecting
Wires