Gree HNTF24/A-D

11
Condensing Unit
Service Manual
CONTROL
No. Name Function Description
1
Signal transmitter ● Signal transmitter
2
ON/OFF button
● Press this button, the unit will be started or stopped, which can clear the timer or sleeping
function of last time.
3
MODE button
● Press this button, the running mode will change as below:
AUTO ; COOL; DRY; FAN; HEAT (only for cooling and heating unit)
4
+/- button
● When press
+
button , the setting temp. will be increased by 1
o
C ,When press
-
button,the
setting temp. will be decreased by 1
o
C. The temp. will be changed quickly by pressing the
button continuously and setting temp. range is 16-30
o
C
5
FAN button
● Press this button once, fan speed will change as below:
Note: Under the DRY mode, the fan will be kept running at the low speed and the fan
speed isn't adjustable.
6
Swing up and
down button
● Simpleness swing mode is defaulted for wireless remote controller, in this mode, press
this button, could turn on or turn off the Up and down swing function.
● When unit is turned off, synchronously press "+" and Up and down swing buttons, it could
be switched between the simpleness swing mode and stationary swing mode, at this
time, blinks 2 seconds.
● In Stationary swing mode, press this button,the angle for Up and down swing as show in
below:
● When up and down swing louver is working,when turn off the unit, the siwng louver will
immediately stop at current position. shows up and down swing louver swings back
and forth as show in the above gure.
7
HEALTH |
SAVE button
● HEALTH function: press the left part of this button,can set up Health function on or off.
After unit is turned on ,Health function ON is defaulted.
● Save energy function: Under Cool mode ,press the right part of this button, the wireless
remote controller will display “ ”, the whole unit will enter into “Electricity Save mode”,
repress this button, the whole unit will quit this mode, other mode button is not available.
Under the Energy Save mode, the temperature and the Fan speed on the wireless
remote controller are not adjustable.
8
Left and right
swing button
● Simpleness swing mode is defaulted for wireless remote controller,in this mode,press this
button, could turn on or turn off the Left and right swing function.
● When unit is turned off, synchronously press "+" and Left and right swing buttons, it could
be switched between the simpleness swing mode and stationary swing mode, at this
time, blinks 2 seconds.
● In Stationary swing mode, press this button,the angle for Left and right swing as show in
below:
● When left and right swing louver is working, when turn off the unit, the siwing louver will
immediately stop at current position. shows left and right swing louver swings back
and forth as show in the above gure.