EasyManua.ls Logo

Gree Versati II+ - Flow Chart Of Troubleshooting; High-pressure Protection E1

Gree Versati II+
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Air-to-water Heat Pump Monobloc Versati
2 3
Earthing: the unit must be
earthed reliably ! The earthing
wire should connect with
special device of buildings.
If not, please ask the qualified
personnel to install.
Furthermore, don't connect
earth wire to gas pipe, water
pipe, drainage pipe or any
other improper places which
professional does not recognize.
Never insert any foreign
matter into uint to avoid
damage . And never insert
your hands into the air outlet
of the unit.
Don't attempt to repair the unit
by yourself.
Improper repair may cause electric
shock or fire, so you should
contact the service center to
repair.
Don't step on the top of the
unit or place anything on it.
There is the danger of fall of
things or people.
Never block the air inlet and
outlet of unit.
It may reduce efficiency or cause
stop of the unit and even re.
Keep pressurized spray, gas
holder and so on away from
the unit above 1m .
It may cause re or explosion.
Please note whether the
installation stand is firm
enough or not.
If damaged, it may cause fall of
the unit and injury of people.
Unit should be installed at the
place with good ventilation to
save energy.
When there is not water in
water tank, never power the
unit on to run.
Notice!
(1) Before installation, please check if the adopted power is accordance with that listed on
nameplate, and check the safety of power.
(2) Before using, please check and conrm if wires and water pipes are connected correctly to avid
water leakage, electric shock or re etc.
(3) Don’t operate the unit with wet hand, and don’t allow children to operate the unit.

Other manuals for Gree Versati II+

Related product manuals