74
Installation and Maintenance
Service Manual
Holder
Connector
Step Procedure
7.Remove panel
a
Remove 3 screws xing evaporator assy.
At the back of the unit, Loosen the clasp of the
connection pipe clamp and then remove the connection
pipe clamp.
First remove the left side of evaporator from
the groove of bottom shell and then remove
the right side from the clasp on the bottom
shell.
Adjust the position of connection pipe on evaporator
slightly and then lift the evaporator upwards to remove
it.
b
c
d
Clasp
Connection pipe
11. Removal Procedure
To Next Page
Loading...
