Wired Remote Controller XK19
9
3.8 Sleep Setting
Sleep setting is shown as Fig.11.
In the Cooling or Dry mode, the temperature will increase by 1
℃
after the unit runs under Sleep
1 for 1hr and 1
℃
after another 1hr.After that, the unit will run at this temperature.
Sleep on: Press Function under on state of the unit till the unit enters the Sleep setting
In the Heating mode, the temperature will decrease by 1
℃
after the unit runs under Sleep 1 for
1hr and 1
℃
after another 1hr. After that, the unit will run at this temperature.
Sleep off: When the Sleep function is activated, press Function to enter the Sleep setting
interface. After that, press Enter/Cancel to can this function.
Fig. 11 Sleep Setting
To Next Page
Loading...
