User’s Notice
The power supply method for all indoor units must be unified.
Prohibit installing the wired controller at wet or sunshine places.
Do not knock, throw or frequently disassemble the wired controller.
Dot not operate the wired controller with wet hands.
The photos in this instruction manual is only for reference, Please refer to the
actual products for the final effect.
In one system network, you must set one indoor unit as the master indoor unit.
Others are slave indoor unit.
The operation mode for the system is basing on that of master indoor unit.
Master indoor unit can switch the mode freely, while slave indoor unit can’t
switch to the mode which will conflict with the master indoor unit.
When the operation mode of indoor unit is conflicting with that of system
because the master indoor unit is changing mode, the operation mode of
slave indoor unit will switch to the operation mode of system automatically.
When two wired controllers control one (or more) indoor unit(s), the address
of wired controller should be different.
Functions with “*” are optional for indoor units. If a function is not included in
an indoor unit, wired controller can’t set the function, or setting of this function
is invalid to the indoor unit
To Next Page
Loading...
