Wired Controller XK55
34
operation are invalid. When it is partial shield, the operation towards remote control of
conductively-closed function of wired controller or button operation are invalid.
When remote control or integrated controller is conducting remote shield towards
wire controller, the main page status bar will display
. When the user is conducting
remote control or key button operation towards wire controller, it indicates the
operation is invalid.
4.2 Entrance guard display function
When there is access control system, the wired controller has the functions that if
you insert card, it will begin operation and if you pull out the card, it will stop operation.
After pulling out, it will memorize and restore the work if you insert the card again. If
you do not insert the card (or imperfect contact of the card), the symbol for pulling out
the card will be displayed, neither remote control nor operation of wired
controller will be effective and icon
will be flickering.
Note:
This model cannot be connected with gate control system on its own
because it cannot detect gate control signal directly. To realize gate control display
and gate control function, it has to be used with wired controller that includes gate
control signal detecting function (used as master and salve wired controller).
To Next Page
Loading...
