Wired Controller XK55
13
Fig 4.6 shows the simple way to install the wired controller. Please pay attention
to the following matters:
① Before installing the product, cut off the power supply of the indoor unit.
Power must be off during the whole installation process.
② Pull out the two-core twisted-pair wire in the wall mounting hole, and pass
this wire through the wiring hole at the back of the base of the wired
controller.
③ Attach the base of the wired controller to the wall, and fix the base with the
wall mounting hole with screws M4 × 25.
④ Connect the two-core twisted-pair wire that passes through to the H1 and
H2 terminals, and tighten the screws.
⑤ Fasten the wired controller panel and the wired controller base together to
complete the installation.
4.1.5 Removal
Fig 4.7 Diagram of wired controller removal
To Next Page
Loading...
