Wired Controller XK55
19
NOTES:
① Under the status of parameter inquiry, the remote control signal is
ineffective.
② If a parameter is invalid, it shows "—".
4.2.2 Parameter settings
You can set the unit's parameters whether the unit is on or off.
Press "Menu" on the home page and then select "Parameter Settings" to enter
the page of parameter settings, as shown below:
Fig 4.12 List of parameter settings
Press an icon to enter the setting of the corresponding function. To enter the
setting of engineering parameters, you need to enter the engineering password. The
default password is 123456. You can change the engineering password on the
To Next Page
Loading...
