Greenlee Textron Inc. / Subsidiary of Textron Inc.
7
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
764 Ratchet Cable Cutter
Maintenance
General
Maintain the tool with care. Keep the blades sharp
and the tool clean for better and safer performance.
Follow instructions for lubricating the cutter; lubrication
prolongs the tool life and enables the tool to cut with
less force. Keep grips dry, clean and free from oil
and grease.
Cleaning the cutter
Blow dirt and/or cable particles out of the drive
mechanism with compressed air.
Lubricating the cutter
Close jaws and place 3-in-one oil or equivalent on the
blades. Oil the jaw bolt (25), spacer (4), and jaw areas
around them. Also oil the master gear (16), and pawls
(15) at their respective shafts (19) and contact surfaces.
Oil the inside of the housing plates (13 and 23) where
contacted by the lever handle plates (14 and 22). Open
and close the cutter to spread the oil.
Disassemble, clean and lubricate the tool if it does not
operate smoothly.
Wear eye protection when using
this tool.
Keep hands away from closing
blades.
Pinch points:
Keep hands away from moving parts.
To Next Page
Loading...
