00967 Deluxe Force Gauge
Greenlee Textron / Subsidiary of Textron Inc. 5 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815/397-7070
Install the force gauge roller assembly using one of the
two mounting adapters provided.
Mounting to Boom Assembly
1. See the manual supplied with the Ultra Tugger™.
After attaching a boom tube to the boom mount, see
Steps 2 - 5 to attach the boom/gauge mount. Then
finish setting up the cable puller.
2. See the illustration. Slide the boom/gauge mount
onto the boom tube. Position it about 4" from the
boom mount as shown.
3. Tighten the set screw.
4. Place the force gauge roller assembly onto the
gauge mount so that the tabs of the mount go
between the roller side plates, as shown.
5. Align the holes and insert the hitch pin.
Mounting to the Ultra Tugger™
1. See the manual supplied with the Ultra Tugger™.
Set up the cable puller with the chain mount, pipe
sheave adapter, or floor mount.
2. See the illustration. Position the puller/gauge mount
between the side plates of the puller. Align the holes
as shown.
3. Insert the hitch pin through the holes.
4. Secure the hitch pin with a hitch pin clip.
5. Place the roller assembly onto the puller/gauge
mount so that one side plate of roller assembly fits
into the U-shaped slot of the mount. Align the holes
as shown.
6. Insert the hitch pin through the holes.
Setup / Installation
4.00
To Next Page
Loading...
