Greenlee EK50ML - Parts List; Component Part Numbers

EK50ML Battery-powered Crimping Tool
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
15
Parts List
Key Part No. Description Qty
52068843 Driver assembly with gearbox and spindle nut
2 Grease retainer cap ................................................................................... 1
3 Spindle nut ................................................................................................ 1
4 Spring-type straight pin ISO 13337–2 x 12 ............................................... 1
5 Yoke .......................................................................................................... 1
6 Compression spring .................................................................................. 1
7 Cup spring DIN 2093–18 x 0.5 x 8.2 ......................................................... 7
8 Shim washer DIN 988–13 x 19 x 0.5 ......................................................... 1
25 Drive assembly 46-gearing/10.8V engine ................................................. 1
52068844 Crimp head (complete) 12 mm
1 Screw, cross recess head M4 x 12 ........................................................... 2
9 Linkage arm .............................................................................................. 4
10 Bolt ø5 x 12 ............................................................................................... 4
11 Crimp head bracket with hole 4.2 mm ...................................................... 2
12 Shim ring DIN 988–7 x 13 x 0.2 steel ........................................................ 4
13 End plate, left ............................................................................................ 1
14 Bolt ø7 x 12 ............................................................................................... 2
15 Parallel pin, hardened ISO 8734–4 x 28 .................................................... 1
16 Gear lever .................................................................................................. 2
20 HSH cap screw ISO 4762–M4 x 18 (DIN 912) .......................................... 2
22 Crimp head bracket with thread M4 ......................................................... 2
24 Compression spring DA 9.8 x L 14, x D 1.4 .............................................. 1
30 Retaining ring DIN 471–7 x 0.8 ................................................................. 4
31 Extension spring DA 3.52 x L 8.7 x D 0.32 ............................................... 1
32 End plate, right .......................................................................................... 1
52068849 Crimp head (complete) 13 mm
1 Screw, cross recess head M4 x 12 ........................................................... 2
9 Linkage arm .............................................................................................. 4
10 Bolt ø5 x 12 ............................................................................................... 4
11 Crimp head bracket with hole 4.2 mm ...................................................... 2
12 Shim ring DIN 988–7 x 13 x 0.2 steel ........................................................ 4
13 End plate, left ............................................................................................ 1
14 Bolt ø7 x 12 ............................................................................................... 2
15 Parallel pin, hardened ISO 8734–4 x 28 .................................................... 1
16 Gear lever .................................................................................................. 2
20 HSH cap screw ISO 4762–M4 x 18 (DIN 912) .......................................... 2
22 Crimp head bracket with thread M4 ......................................................... 2
24 Compression spring DA 9.8 x L 14, x D 1.4 .............................................. 1
30 Retaining ring DIN 471–7 x 0.8 ................................................................. 4
31 Extension spring DA 3.52 x L 8.7 x D 0.32 ............................................... 1
32 End plate, right .......................................................................................... 1