To Next PageTo Next Page
Need help?Do you have a question about the Greenlee SITE-RITE 840A and is the answer not in the manual?
General| Category | Power Tool |
|---|---|
| Conduit Capacity | 1/2" to 2" |
| EMT Capacity | 1/2" to 2" |
| Rigid Capacity | 1/2" to 2" |
| IMC Capacity | 1/2" to 2" |
| Bending Angle | 0 - 90 degrees |
| Model | SITE-RITE 840A |
Details the Greenlee aluminum and iron SITE-RITE® benders and their intended use.
Explains the manual's role in familiarizing operators with safe operation of the benders.
Highlights critical safety precautions for operating the hand benders, including understanding instructions and proper tool use.
Instructions for marking the conduit and aligning it with the bender's arrow for accurate bending.
Guidance on foot pressure and visual cues for stopping the bend at the correct angle.
Advice on maintaining optimal body position and consistent pressure during bending with the handle down.
Tips for quality bends and a detailed method for marking conduit for 90° stub bends.
Procedure for adjusting conduit that has been bent beyond the intended angle.
Steps for creating two consecutive 90-degree bends in the same plane on a conduit.
Explains how to calculate and execute offset bends to navigate around obstructions using multipliers.
Reference table providing shrink amounts and center-to-center distances for various offset angles and depths.
Details calculating shrinkage and distances for offsets when bending towards an obstacle.
Explains the concept and basic calculation for creating three-bend saddles to avoid obstructions.
Provides specific measurements for marking conduit for 45-degree three-bend saddles.
