Time ‘Switch Live’ is Active
0– 5 minutes
5–10 minutes
10 – 15 minutes
15+ minutes
Over-run Boost Period
No over-run
5 minutes
10 minutes
15 minutes
8 9
3.1.4 To Change the Greenwood TimerSMART
T
M
Setting
The Greenwood TimerSMART
TM
monitors the length of time the unit has
been in boost mode via the Switch Live. Once the Switch Live is
deactivated the Greenwood TimerSMART
TM
over-run period should
continue to run the unit for a calculated time if required.
Note: The first 5 minutes should not activate an over-run.
To identify current fan status, press any button to activate the panel.
Upon identification of control status, either press [ ] to activate or
deactivate the Greenwood TimerSMART
TM
. Please note the light should
come on to indicate that the function is active.
Factory set to OFF
Option’s ON / OFF
Note: After approximately 10 seconds of
inactivity, the control panel lights should turn
off and save selection settings.
Note: This feature can be activated
at the same time as the Greenwood
HumidiSMART
TM.
3.1.5To Change the Greenwood HumidiSMART
T
M
Setting
The Greenwood HumidiSMART
TM
monitors the humidity of the extracted
air at all times. A rapid rise in humidity from a bath / shower, should be
picked up by the sensor and should cause the fan to automatically
switch to Boost mode.
When humidity falls below a calculated threshold close to background
levels, the fan should return to trickle mode.
To identify current fan status, press any button to activate the panel.
Upon identification of control status, either press [ ] to activate or
deactivate the Greenwood HumidiSMART
TM
. Please note the light should
come on to indicate that the function is active.
Factory set to OFF
Option’s ON / OFF
Note: After approximately 10 seconds of
inactivity, the control panel lights should
turn off and save selection settings.
Note: This feature can be activated
at the same time as the Greenwood
TimerSMART
TM.
To Next Page
Loading...
